Outside Thermo to connect to hub

Comments: 4

Oldest • Newest • Most likes • Fewest likes

• Add a comment
• 10 Nov, '19
  Rob

  What would be amazing would be if you could set the floor temp based on outside temp. The front of my house is heated withs rads and the back with underfloor heating. They compete with each other and the underfloor heating loses so i've switched to just setting the floor temp. This works but needs constant manual adjustment depending on the outside temp. If I could set it up so that e.g. if outside temp is 10, floor temp 23, 7 then 24, 4 then 25 etc. It would work amazingly

  Copy link to this comment
• 13 Nov, '19
  Rob

  A remote sensor to connect to the hub would be useful both for programming purposes, but also allow people to remotely monitor garages, greenhouses etc. or any other areas that they would like to check up on.

  Copy link to this comment
• 13 Dec, '19
  Grahame Crispin

  Heatmiser’s Wireless Air Sensor can achieve this. Although Heatmiser technical dept have told me the operating range of the sensor is 5-35 degrees c, it seems to work outside this range.

  Copy link to this comment
• 29 Oct, '20
  Paul H

  My understanding is that the Heatmiser Wireless Air Sensor can only communicate directly with the neoHub, so it has to be in range of the neoHub. This severely limits where you can locate the Wireless Air Sensor. Last year I suggested changing the Wireless Air Sensor to enable it to join the wireless mesh network, but this suggestion was rejected ... I'm assuming due to hardware limitations in the current Wireless Air Sensor, but maybe Heatmiser have a new version planned that can join the wireless mesh network.

  Copy link to this comment